Ranchers.net Bull Session

 

Log in Register Ranchers.net Ranchers.net's Bull Session Forum Index FAQ Memberlist Search


Thermosink waterer help...

 
Post new topic   Reply to topic    Ranchers.net's Bull Session Forum Index -> Ranch Talk
Author Message
gknitel
Member
Member


Joined: 22 Jan 2012
Posts: 1
Location: Lethbridge

PostPosted: Sun Jan 22, 2012 3:20 pm    Post subject: Thermosink waterer help... Reply with quote

Hi... I see some of you have thermosink waterers... I have a thermosink single waterer... During this last cold spell it no longer has been filling – albeit it is not froze up, the pressurized water is working from our pumphouse end, the float is attached and seems to be doing what it is supposed to, and I can just reach the water in the water storage side just below the second linking arm that attaches to the float. So my conclusion is that there is something preventing the water from flowing into the water storage side. Although I did not adjust the external shut-off, it does seem logical that I try adjusting that. However I cannot turn it nor push it nor pull it, without considerable force.

Can somebody tell me how to adjust the external shut-off?

Do you have other ideas as to why the water storage is not filling? thanks


Back to top
DUKE
Member
Member


Joined: 02 May 2006
Posts: 5

PostPosted: Sun Jan 22, 2012 6:20 pm    Post subject: Reply with quote

We have a couple of these waterers and my advice is to. If you can shut your main pump down and pull the riser pipe on the the filling side of the tank.Check to make sure there is no small rocks caught up in the float valve.Turn the main water on and flush the line for a few seconds and reassemble. and turn water back on and see if it works. As far as the shut-offs on the tanks they always turn hard. So if you shut the main water off and take the pressure off the line it main turn on and off easier. Try that see how it works


Back to top
Cedarcreek
Member
Member


Joined: 23 May 2006
Posts: 513
Location: Eastern Montana

PostPosted: Sun Jan 22, 2012 6:21 pm    Post subject: Reply with quote

The shut off works by turning it left to shut off and right for on. It should be turned to the right as far as it will go. 1/4 turn from off to on. You have to use a wrench on it. Unless your float is about 1/2 submerged your not getting water in to it. On mine both sides fill to about 6" from the top, much fuller than that and the float came up against the lid and didn't shut off.


Back to top
Display posts from previous:   
Post new topic   Reply to topic    Ranchers.net's Bull Session Forum Index -> Ranch Talk All times are GMT - 6 Hours
Page 1 of 1

 




Powered by phpBB
Copyright © 2001-2011 Ranchers.net
All times are GMT - 6 Hours