Search results for query: *

Rowse Rakes Burwell 308-348-2276 or you can try Mays Repair Bassett 402-684-2777 Hope this helps

What brand

You should beable to push them ahead and there will be holes on the sides to take the bolts and keepers out.

Denny got it to go this time so you can check again.

Denny I sent you a pm if it didn't come let me know. Thanks

Denny is that with 2 center gates and how heavey axles

Thanks for the info. I'll keep looking

Anyone have one and how do you like it. Looking at a 7/24 steel

Might try a load board

I havent changed one in a while. A friend of mine got mad at his BR 780 not a very old baler net rap would not work right called the dealer to have someone come out they didnt show up then the top clutch went out. He took it to his shop cleaned it up unhooked called the dealer told them to come...

Not to tuff. Take drive chain off,bolt out of the end of the shaft pull first half off should be a snap ring on the shaft take it off and inside half should come off. Write a $300 check and put back together. On my 664 if I grease it to much it will slip. I hope this helps.

I still run a IH MD on a mower

Mine will do the same thing.

Thanks for the info. I got it off not bad at all.

I need to take the pto off my IH 1086 and get new clutches put in. Does anyone know how big of job it is? I'm trying to save some money and take it out and then to the shop. Thanks

Justin is right check the micro switch.

All you need is some WD40. I don't know what is is called but the thing that lets the arms trip and stops them has some rust in it. trip your arms and go around on the right side and spray it with WD 40 and work it back and forth. I'm sure that is clear as mud but it will work. I have a 664 and...

Tenbach I know where there are some fall pairs. I sent you a pm.

It's not getting any fuel yet I bet. I had the same thing today with my old 7060 AC.

Works the same way on the 664's