Justin
Well-known member
has anybody had any experience with these? good/bad?
i have an IH 666 with no 3pt. and was debating on putting one of these on it.
i have an IH 666 with no 3pt. and was debating on putting one of these on it.
add on 3pt. hitch
- Thread starter Justin
- Start date
Big Muddy rancher
Well-known member
Justin said:
These are buitl about 60 miles from me.
http://www.ebourassa.com/page.cfm?pgID=81
Justin
Well-known member
Big Muddy rancher said:
so are they any good?
little bow rancher
Well-known member
we put one on a 3020 had to make a few changes , ok had to make alot of changes , but that was 15 years agoJustin said:
Hayguy
Well-known member
i put a hold-on industries one on a 1085 massey several years ago,fair amount of adapting was necessary. i remember that the pto clearance was a real problem. also make sure there is a float position on either the tractor or 3pt hydraulics, mine did'nt i had power down but no float, tough for blading, good for 3pt post hole auger, till you get stuck down hole 
